Thingiverse
Button Box for Simracing
door cowtown
3
Downloads
6
Likes
0
Makes
Sized to tuck under/over/on the side of a Mige-motor setup, but can be mounted anywhere really.
Assemble the parts for closed-back or open-backed setup. Stack the box if needed for increased volume - each length is 30mm, so any size can be created.
If you want a regular box, use the "PanelFront" file. The "PanelFrontEars" version of the front panel protrudes 5mm on each side, so it can be installed as shown in the first picture, under the steering wheel bracket.
Requires the parts shown in photos:
qty 6 M3 Heat Sets
qty 6 M3 Screws + Washers
qty 6 12mm Buttons
qty 1 Joystick Button Board (shown) / Leonardo / Pi / etc.
Assemble the parts for closed-back or open-backed setup. Stack the box if needed for increased volume - each length is 30mm, so any size can be created.
If you want a regular box, use the "PanelFront" file. The "PanelFrontEars" version of the front panel protrudes 5mm on each side, so it can be installed as shown in the first picture, under the steering wheel bracket.
Requires the parts shown in photos:
qty 6 M3 Heat Sets
qty 6 M3 Screws + Washers
qty 6 12mm Buttons
qty 1 Joystick Button Board (shown) / Leonardo / Pi / etc.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
