Thingiverse
Button Case
von rich_short
15
Downloads
15
Likes
0
Makes
This is a button case for small push button.
It was create as an addition to the very nice snap together lamp (http://www.thingiverse.com/thing:27062)
The switch was purchased from Maplin in the UK, however its probably a general part.
The print shown is using a standard USB cable. I would recommend taking of a little more of the outer insulation as its quite a tight fit inside the button shell.
It was create as an addition to the very nice snap together lamp (http://www.thingiverse.com/thing:27062)
The switch was purchased from Maplin in the UK, however its probably a general part.
The print shown is using a standard USB cable. I would recommend taking of a little more of the outer insulation as its quite a tight fit inside the button shell.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!