Thingiverse
Button for CB Microphone
di tghost8
6
Download
3
Likes
0
Makes
The button for our CB radio at work broke so I made this to replace it.
When it gets imported into Cura, it up scales it probably because Sketchup uses standard and Cura is metric, so when i printed it I set the x length to 45mm, and it worked perfectly. Once it's printed you may need to sand the little pegs a bit to get it to fit just right. I used supports as well.
When it gets imported into Cura, it up scales it probably because Sketchup uses standard and Cura is metric, so when i printed it I set the x length to 45mm, and it worked perfectly. Once it's printed you may need to sand the little pegs a bit to get it to fit just right. I used supports as well.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
