Thingiverse
Button wall hook
door Tomo_designs
115
Downloads
144
Likes
0
Makes
Button hook
No support needed
I hope you like it. I printed it out in matte black and advise you to do that too because it is beautiful.
Rubber band
You will need a rubber band that is 8 mm wide. It will be a tight fit but it works. It also works with a smaller width rubberband but it will be less clean.
How to mount
You can use a screw to mount it to the wall and glue the button and mount for a good permanent fit. They fit together without glue but there is a chance that it will fall off.
I made a tutorial video
Check out this video and you will see how I assemble it. And to know know more about my work
No support needed
I hope you like it. I printed it out in matte black and advise you to do that too because it is beautiful.
Rubber band
You will need a rubber band that is 8 mm wide. It will be a tight fit but it works. It also works with a smaller width rubberband but it will be less clean.
How to mount
You can use a screw to mount it to the wall and glue the button and mount for a good permanent fit. They fit together without glue but there is a chance that it will fall off.
I made a tutorial video
Check out this video and you will see how I assemble it. And to know know more about my work
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
