Thingiverse
Buzzer Mk2
door wagenerp
10
Downloads
5
Likes
0
Makes
This is my design for a big, round button, comprised of five to six printed pieces and a few additional components:
- A single pushbutton switch: I designed this to house standard MX three-pin keyswitches
- A number of springs: Configurable number depending on type of spring and desired resistance. My default design allows up to 12 springs to be inserted.
- M4 screws and nuts: In my default six-piece setup I use 38mm M4 screws.
- M3 screws and nuts: A few short screws will be needed to connect tower, shaft and base together.
- A single pushbutton switch: I designed this to house standard MX three-pin keyswitches
- A number of springs: Configurable number depending on type of spring and desired resistance. My default design allows up to 12 springs to be inserted.
- M4 screws and nuts: In my default six-piece setup I use 38mm M4 screws.
- M3 screws and nuts: A few short screws will be needed to connect tower, shaft and base together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!