C64 Commodore 64 TOMv3 USB mouse interface case housing

You may find on ebay some really clever interface, named TOM, for your C64 which allows to connect modern mouse, keyboard or gamepads by USB. It is also suitable for Atari and Amiga. It comes with typical housing, however this housing have a couple disadvantages. Especially in the case of C64 you have to use some cable adapter to connect TOM. It is inconvenient and looks bad. So, I decided to develop new case which looks better and doesn't require any cable adapters to use with C64... :)

First, simply remove old housing. Use the 6mm drill and make two holes in the metal frame of DB9 connector a little bigger (but not too big or you will destroy the frame!!!). It will allow to hide heads of screws as deep as possible in the frame (take a look on the attached pictures). Slide TOM into the new printed housing. If you find some problems when slides in, try to push in and pull out the board couple of times and use some force again. Sometimes it fits really tight. Then mount it by using t