Thingiverse
Cable Catcher
von kpaulsen
3
Downloads
1
Likes
0
Makes
Clamp this to your table to hold you charging cables.
Print the bolt or use a metal M10 1.25 bolt. If printing the bolt, you might need to scale it down in the x and y axis to about 95%. Otherwise it might be too tight.
Print the bolt or use a metal M10 1.25 bolt. If printing the bolt, you might need to scale it down in the x and y axis to about 95%. Otherwise it might be too tight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
