Thingiverse
Cable chain end
von 79rulz
8
Downloads
3
Likes
0
Makes
Cable chain end with cable holder, two fixing holes for DIN 912 M2.5 mm., printed in PLA, 100% infill, supports, the Gcode attached is for an Artillery X1 with this adjustments, Solidworks editable part file attached too.
Peace!
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Peace!
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!