Cable Chain Mount

This is a rework of the cable chain mount on the Tronxy X5S, but could be used on any core X Y cube. When receiving the new X5S release the connector block has been removed and the cables are soldered together. When Tronxy did this they made the cables too short, and a complete rewire is required. This mount has a cable management box built in to correct this issue. There is space to install a solder tag strip inside, and as you see in the photo I also used a terminal block to be used for the hot end cables to make it easy switch out.
I have also added a boom arm to keep the Bowden tube away from the Y stepper on the Tronxy plus it helps with the tube sagging and fouling with the cable chain.
You will need
M2 Screws 4 x 5mm
M3 Screws 4 x 10mm I used computer case Blanking plate screws
M3 nut and bolt 40mm
cable strain relief.