Thingiverse
Cable chain
von Rob65
161
Downloads
106
Likes
0
Makes
The original did not print that well on my printer, resulting in a lot of friction. I changed the geometr to suit my application.
Finally I ended up with a number of parameters that can be changed in SolidWorks to change the dimensions.
The default demension gives small links with 14mm between the link points (total length 24.1 mm), 11.4 mm heigh and 18 mm wide. The opening for the cables is 8x10 mm, just large enough for my small application.
Play around with the SolidWorks model and change the height, length and width parameters to change this.
There are no end-pieces yet but it should not be that hard to add your own ;)
Finally I ended up with a number of parameters that can be changed in SolidWorks to change the dimensions.
The default demension gives small links with 14mm between the link points (total length 24.1 mm), 11.4 mm heigh and 18 mm wide. The opening for the cables is 8x10 mm, just large enough for my small application.
Play around with the SolidWorks model and change the height, length and width parameters to change this.
There are no end-pieces yet but it should not be that hard to add your own ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
