Cable Clamp for OpenGrid / Underware

This two-piece cable clamp is designed for organizing wires on OpenGrid / Underware panels. The body has an open slot where you lay the cable, and a ring nut screws on to hold it securely in place. It mounts directly to the grid for a clean fit in desks, racks, or workshop setups. I created it to address common issues with other options: printed channels fix paths that are hard to change later, zip ties are single-use, and Velcro can be fiddly to mount / adjust. This clamp provides simple, reusable anchor points—just position it, drop in the cable and hand-tighten the ring. Use it to secure cable starts or ends, guide bends, or create loops for slack. It's practical for home offices or other environments where setups evolve, like swapping peripherals or testing gear. The design aligns with the tile spacing, so multiple clamps can be used next to each other. For printing, use PLA or PETG for strength; print the body upright for straight slots and the ring flat on its open side. Go w