MakerWorld
Other Hobby & DIY
Zum Modell
Cable Clamp
11
Downloads
1
Likes
8
Makes
Cable Clamp used for holding wires.I used in inside my canopy to easier determine the cable length.it's made for 7mm, so it should hold any wire you wish. A hole can be drilled in the middle if you want it attached to sometihng. But this is made for hiding, and therefor smaller. You can still make it smaller. It's made to easily scaleable. You can cut som of the bottom if you wish to make it smaller also. -Hope you like it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
