Thingiverse
cable connect
door pixelhaufen
49
Downloads
37
Likes
1
Makes
Simple clip to connect two cables. I used an old filament spool to wind up an extension cord. The clip helps to avoid a tangled mess of cables.
The following can be adjusted:
* diameter of the cable
* height of the clip
Since the edges seemed to be a bit sharp I rounded them a little bit and smoothed the layers after printing.
The following can be adjusted:
* diameter of the cable
* height of the clip
Since the edges seemed to be a bit sharp I rounded them a little bit and smoothed the layers after printing.
pixelhaufen publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
