Thingiverse
cable connect
von pixelhaufen
49
Downloads
37
Likes
1
Makes
Simple clip to connect two cables. I used an old filament spool to wind up an extension cord. The clip helps to avoid a tangled mess of cables.
The following can be adjusted:
* diameter of the cable
* height of the clip
Since the edges seemed to be a bit sharp I rounded them a little bit and smoothed the layers after printing.
The following can be adjusted:
* diameter of the cable
* height of the clip
Since the edges seemed to be a bit sharp I rounded them a little bit and smoothed the layers after printing.
pixelhaufen veröffentlicht auch auf
11 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
