Cable guide for Original Prusa MK2

Just a simple clip to hold up the extruder cables as mine were hanging onto the bed. Didn't want to print the cable chains just yet. I only made a hole for the USB but its easily removed if needed without any tools.

I used the default MK2 profile to print.

**UPDATE**
I do not use this clip anymore, as it was a quick fix.

I had to rebuild my extruder because the pinda probe broke off and I was not able to glue it back on properly. After twisting the filament in the cable bundle upwards and tie wrapping the cable bundle better it no longer drags on my printer bed.
You might want to do the same, there are enough tie wraps supplied to try again.