Thingiverse
Cable Guide
door AWilly11
57
Downloads
46
Likes
1
Makes
this is something I came up with to hold my dropper post cable instead of spending money on one. It works pretty well. It attaches with a zip tie but i would suggest scaling it up slightly if printing with a material such as ABS where it doesn't have quite as accurate tolerances. I had to shave down my zip tie just a little to make it fit. The back part isn't needed but is included. without it, it will fit any size post.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
