Thingiverse
Cable holder
von HoneyBaddger
45
Downloads
23
Likes
0
Makes
A cable holder. You need rather small zipties and double-sided adhesive tape.
Print without support, depending on the printer, you would need to clean up the small tunnels to get the ziptie through.
This is just for fun! 100 of these cost about 3€... just sayin.
Print without support, depending on the printer, you would need to clean up the small tunnels to get the ziptie through.
This is just for fun! 100 of these cost about 3€... just sayin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
