Thingiverse
cable holder
von deepwell
2
Downloads
0
Likes
0
Makes
used 3M double side adhesive tape to fix the holder to the bottom of the table.
Printed scaled to 70%,100%, 70% (as in the picture) still works fine, though it needed some force to be applied to open the clip, it got a bit stuck to the other part.
Printed scaled to 70%,100%, 70% (as in the picture) still works fine, though it needed some force to be applied to open the clip, it got a bit stuck to the other part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!