Thingiverse
Cable holder
von 3d-maxx
2
Downloads
1
Likes
0
Makes
This is a simple cable holder, I made two versions with two variants, one being slightly tighter than the other so it can fit correctly depending on the surface it is being attached.
In the first images the one in the left is the tighter.
In the first images the one in the left is the tighter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
