MakerWorld
Decor
Zum Modell
Cable Raceway
28
Downloads
11
Likes
13
Makes
This cable raceway can accommodate more than six wires. Both large and thin wires work. Can just be adhesived to the underside of the desk/wherever it needs management. It is natuarally sprung closed by the clip, which just uses the elastic nature of PLA. Print on its side, so the hinge is pointed vertically. It is a tight tolerance of 0.25 mm for both the hinge and the clip, so make sure your print is set up for accuracy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
