Thingiverse
Cable / Wire Floor Protector
door TNG_Robotics
244
Downloads
282
Likes
2
Makes
Cable / wire floor protector cover is designed to add multiple sections by snapping them together. This allows you to cover a large area on the floor to protect cables from being walked on.
It will print under most settings. You can print it like normal (as it would sit on the floor) without using supports, assuming you are ok with a slightly rougher under side where the cables go. The filament will successfully bridge the gap after 2-3 layers. This leaves a slightly rougher under side where the cables rest, but this is hidden anyway so does not affect the aesthetics. It will also print on its side for those with large vertical 3D print areas.
Dimensions: 190 mm length (+7 mm snap-on connector) x 40 mm width x 11 mm height
Cable channel dimensions: 190 mm length x 20 mm width x 7 mm height
It will print under most settings. You can print it like normal (as it would sit on the floor) without using supports, assuming you are ok with a slightly rougher under side where the cables go. The filament will successfully bridge the gap after 2-3 layers. This leaves a slightly rougher under side where the cables rest, but this is hidden anyway so does not affect the aesthetics. It will also print on its side for those with large vertical 3D print areas.
Dimensions: 190 mm length (+7 mm snap-on connector) x 40 mm width x 11 mm height
Cable channel dimensions: 190 mm length x 20 mm width x 7 mm height
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
