Thingiverse
Calculus prop
von mhussin
3
Downloads
3
Likes
0
Makes
This shows off a volumes by slicing problem from Calculus II.
It is an approximation to the object formed by circles laying perpendicular to the x-axis whose edge lies on the curves y=-x^2+2 and y=x^2.
This design was created as part of the University of New Hampshire's ET401 "Introduction to 3D Printing" course. You can find design plans to this project and many others at; http://3dprinting.illustratingmath.com
It is an approximation to the object formed by circles laying perpendicular to the x-axis whose edge lies on the curves y=-x^2+2 and y=x^2.
This design was created as part of the University of New Hampshire's ET401 "Introduction to 3D Printing" course. You can find design plans to this project and many others at; http://3dprinting.illustratingmath.com
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!