Thingiverse
Calibration Steps
von kraq
3
Downloads
0
Likes
0
Makes
A simple calibration test made in Solid works.
Long sides are 20mm, short sides are 10mm and the middle square height is 15mm (just for fun). This way you have a few different lengths to test your printer calibration while using less filament then printing a 20mm cube.
Long sides are 20mm, short sides are 10mm and the middle square height is 15mm (just for fun). This way you have a few different lengths to test your printer calibration while using less filament then printing a 20mm cube.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
