Thingiverse
Camera Bracket
by Bob68
3
Downloads
2
Likes
0
Makes
I made this because the cheap tripod that i had tipped over with the camera and broke.
This bracket can be adjusted to give nearly any angle that you wish. Also it can be moved back and forward to keep the camera balanced. The holes in the base and top are 7mm, so will take a standard 1/4" bolt. The bolt handle is for a 1/4" bolt so it will be easy to tighten by hand.
The picture shows the shorter supports (No.2, 75mm), but i have included 125mm (No.1).
The bracket uses 12 x 4mm bolts (20mm), 36 x 4mm washers and 6 x 4mm nylock nuts. The nuts and washers combination, was so that i could set how stiff that i wanted the movement to be.
This bracket can be adjusted to give nearly any angle that you wish. Also it can be moved back and forward to keep the camera balanced. The holes in the base and top are 7mm, so will take a standard 1/4" bolt. The bolt handle is for a 1/4" bolt so it will be easy to tighten by hand.
The picture shows the shorter supports (No.2, 75mm), but i have included 125mm (No.1).
The bracket uses 12 x 4mm bolts (20mm), 36 x 4mm washers and 6 x 4mm nylock nuts. The nuts and washers combination, was so that i could set how stiff that i wanted the movement to be.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
