Thingiverse
Camera Hot Shoe Interface
door prdeppe
3
Downloads
1
Likes
0
Makes
This is an interface to a standard camera hotshoe, with ground and center (flash) contacts only.
Use spring contact pins: MEETOOT 20pcs Spherical Tipped Spring Loaded Probes Testing Pins Patch Thimble 4mm, Amazon: https://www.amazon.com/dp/B09P8HS8TY?psc=1&ref=ppx_yo2ov_dt_b_product_details
Solder #24 wires to the to the top of the pins at a right angle to the pin.
Clean out the pin holes with a #53 drll bit.
Insert the pin/wire assembly and press home. The cap may be glued on with Super Glue.
Use spring contact pins: MEETOOT 20pcs Spherical Tipped Spring Loaded Probes Testing Pins Patch Thimble 4mm, Amazon: https://www.amazon.com/dp/B09P8HS8TY?psc=1&ref=ppx_yo2ov_dt_b_product_details
Solder #24 wires to the to the top of the pins at a right angle to the pin.
Clean out the pin holes with a #53 drll bit.
Insert the pin/wire assembly and press home. The cap may be glued on with Super Glue.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
