Thingiverse
camera mount
von MasterTAng
9
Downloads
6
Likes
0
Makes
Camera mount for stative whit hole for M6 bolt
Infill: at least 30%, i think 50% is better depending on the weight of your camera or whatever you'll mount
support: not needed
The print on the photos turned out horrible but its working perfectly so far
Infill: at least 30%, i think 50% is better depending on the weight of your camera or whatever you'll mount
support: not needed
The print on the photos turned out horrible but its working perfectly so far
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
