Thingiverse

Camera Mount - TX03

von murrayp0473

43 Downloads

22 Likes

0 Makes

I redesigned the camera mount to fit a Eachine TX03. The camera sits on the raised base nicely. I used a bit of hot glue to secure the bottom of the camera onto the raised base. I also included a picture of the orientation for the camera mount. Place the spring clamp onto the printer bed. I did not test with previous Eachine FPV cameras, but I would assume they will fit the camera mount as well.

camera mount eachine tx01 Eachine TX02 eachine tx03 fpv fpv camera mount microquad micro quadcopter miniquad Quadcopter tx01 TX02 TX03 camera mount eachine tx01 Eachine TX02 eachine tx03 fpv fpv camera mount microquad micro quadcopter miniquad Quadcopter tx01 TX02 TX03

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat