Camera Slider (v1)

This is an idea to make a low-cost camera Slider.

For updates you can visit the YouTube playlist:
https://www.youtube.com/playlist?list=PLvk7sY8SF1BXI4Sg5dxGCJXElCUVvc1Aw
And subscribe to the channel.


Materials:
1x NEMA 17 Stepper Motor
1x MG995 Servomotor
1x 608zz bearing
4x M5x30 bolt
4x M5 nut
6x M4x8 bolt
2x M4 nut
5x M3x8 bolt
1x M3x40 bolt
2x M3 nut
1x gt2 pulley
1x gt2 idler pulley


3d printed parts:

1x base2.stl (40% infill, 0.28mm layer height)
1x baseMotor.stl (40% infill, 0.28mm layer height)
1x carriage.stl (40% infill, 0.2mm layer height)
1x coupler.stl (40% infill, 0.2mm layer height)
1x eccentricSpacer.stl (60% infill, 0.2mm layer height) *There are 4 pieces in the stl.
1x gearBearing.stl (40% infill, 0.2mm layer height)
1x gearServo.stl (40% infill, 0.2mm layer height)