Camera Snap Fit Quick Release Plate and Mount

This model is inspired by quick release systems made by brands like ulanzi, smallrig, neewer etc.It is snap fit and only requires pressing the buttons on both sides to release the plate. This model is only tested with ASA, your results may vary with other filaments due to differences in stiffness. It should work with PLA and PETG but I do not know if the spring will feel the same. I recommend using my print profile, as it has all the necessary settings already set. Hardware required:4x M3 6mm countersink screws (3mm to 6mm works)4x M3 heat inserts (maximum length 6mm)1x ¼ inch camera screw 16mm x 16mm x 10mm - Link Assembly notes:Make sure that the buttons can pass through the holes with no effort, they should fall off if you let them slide out before assembly. Due to the supported part above the button hole, you might need to clear any filament left from the bridging. The design has lower tolerance for that part but your results may vary. The easiest way to clean up bridges for me is