MakerWorld
Electronics
Go to Model
Capacitive Mositure Sensor ESP32
99
Downloads
65
Likes
59
Makes
Created an enclosure for a capacitive moisture sensor and ESP32-C3 Mini. The fit is snug. The sensor orientation must match the one shown in the pictures due to a collision with components on one side. The connector, without cables, fits inside the case, encouraging direct soldering of cables instead of using the connector. The F3D file is included for further modifications or adjustments, as every Chinese board can vary slightly in design.If you decide to leave the original connector in place, it is strongly advised to use electrical tape to cover its pins!!!The connection should look something like this Boost MeBecause sometimes we all need a little boost—no coffee required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
