Slicer Discord
Cape May Insert – 3D-printbaar model van Thingiverse Thingiverse

Cape May Insert

door Patella
21 Downloads
11 Likes
1 Makes
Model downloaden
Cape May Insert. Holds sleeved cards. (It should hold just about any sleeves you throw at it. (I had some super-thick Titan Shields for the large cards, and it holds those, so...) This doesn't work so well as a table organizer, just because it took a little work to get all those minis organized.

A few notes:
* I know that the Landmark Bases are not player specific pieces. They just happen to fit 5 to a player tray, so that's where they went. Obviously share them out as needed during play.
* In the same area as the Landmark Bases, I placed the Prestige Tokens. You can't really see them in any photos and I figured folks might ask.
*The Token spaces in the Victorian Minis tray are NOT the same size. Cottage Tokens go in the two left-most spaces and Shop Tokens go in the two right-most. Make certain the Shop tokens go in with a flat side up/down and "points" to the left/right.
* The Player Markers are a little tight in their area. (That's also where I put the Income Tokens
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie