Thingiverse
CapNRing
von MadVampy
39
Downloads
19
Likes
0
Makes
Printed some of the originals and found they pushed in the valve pin so I made the cap a little deeper to stop that, then a friend asked if I could make it so it held a spare tank O-Ring and i then again changed it to allow for that. I'll add both the one with and without the O-Ring holder. Printed this in ABS (as I do with all my prints)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
