MakerWorld
Music
Zum Modell
Capra Straps
164
Downloads
26
Likes
45
Makes
Printing Instructions:All of these straps are optimized for 95a shore hardness TPUThe simplest explanation of the print settings is that FOR THE CENTER SECTION ONLY you need to set the top and bottom layer count to 0, set the wall count to 1, and the infill pattern to the desired mesh. Below are some pictures of these settings in various slicers.Orca Slicer:
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
