Thingiverse
Captured Bolt
von flashboiler
1
Downloads
2
Likes
0
Makes
My take of the old captured bolt. 1mm and 1_5mm refer to the gap between the bolt and nut. On my Prusa the 1mm was a bit hard to turn at 1st and the 1_5 is just a bit sloppy but acceptable.
Printed with the bolt standing up, the nut near the bottom. Use "Support on build plate only" (PrusaSlicer) or eq. I used .3mm layer height with PLA.
Enjoy!
Printed with the bolt standing up, the nut near the bottom. Use "Support on build plate only" (PrusaSlicer) or eq. I used .3mm layer height with PLA.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!