Thingiverse
Case for DC-DC Converter Adjustable Step-Down Module
von McDoS
118
Downloads
98
Likes
1
Makes
Case for adjustable DC-DC stepdown converter with display (like this: https://ru.aliexpress.com/item/Free-Shipping-Electrolytic-capacitor-50v2200uf-50V2200-50PCS/1258173179.html). PCB dementions 60mm * 37mm.
I'm soldered a new 17mm-height buttons instead defaults.
The board is held by the screws housing. Using 3,0mm*20mm screws.
Holes for 2mm diameter wires, but you can use more thicker, just break a "wire separator" in bottom part.
if you do not need any symbols on top cover - use "top_clean.stl". (rotate top cover to 180 degrees)
I'm soldered a new 17mm-height buttons instead defaults.
The board is held by the screws housing. Using 3,0mm*20mm screws.
Holes for 2mm diameter wires, but you can use more thicker, just break a "wire separator" in bottom part.
if you do not need any symbols on top cover - use "top_clean.stl". (rotate top cover to 180 degrees)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
