Thingiverse
Case for Digispark clone
von kelemenb
6
Downloads
4
Likes
0
Makes
This is a top shell to form a box around a Digispark clone.
It also incorporates a wood piece of size 27x28x12mm
The hole on the top is for attaching a potentiometer to the device.
(A knob was also added to this pack as a bonus. The knob will be likely to be drilled from under to the exact size after the print.)
Print it from transparent plastic to see the internal LEDs shining through the case.
Article: https://sharedinventions.com/?p=561
YouTube video: https://youtu.be/6G-Xhe0twYM
It also incorporates a wood piece of size 27x28x12mm
The hole on the top is for attaching a potentiometer to the device.
(A knob was also added to this pack as a bonus. The knob will be likely to be drilled from under to the exact size after the print.)
Print it from transparent plastic to see the internal LEDs shining through the case.
Article: https://sharedinventions.com/?p=561
YouTube video: https://youtu.be/6G-Xhe0twYM
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
