Thingiverse
Case for pulsesensor
door egil
26
Downloads
27
Likes
1
Makes
This is a case for the optical heart pulse sensor from pulsersensor.com. See http://www.pulsesensor.com for details.
The case should build easily, without extra support. Before assembly, clean up the wire channel, for instance with a suitably sized torx driver. Insert the two outer wires one at a time through the channel before inserting the centre wire. The sensor itself should snap in place. You may add a dab of glue in the wire channel to provide some strain relief.
The case should build easily, without extra support. Before assembly, clean up the wire channel, for instance with a suitably sized torx driver. Insert the two outer wires one at a time through the channel before inserting the centre wire. The sensor itself should snap in place. You may add a dab of glue in the wire channel to provide some strain relief.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
