case for Tinyjoypad rev2 - variations

I've adapted Daniel's ingenious design a bit to my needs. Perhaps someone can use it:
1. Depending on the manufacturer, the pins of some through-hole components were so long that they touched the bottom. Because cutting them off can damage the pads, I added recesses to the corresponding areas of the case (TJP_caseBack_lowerings.stl).
2. I use one of my joypads exclusively with cartridges. Therefore, I didn't solder the IC socket and closed the opening in the case instead (TJP_casefrontOC.stl).
3. I wanted to regularly change the Attiny85 (PU version) on another joypad. This was difficult to do with the existing opening. I therefore modified the opening so that a so-called chip extractor could be inserted into the Attiny85 (TJP_casefrontChipEx.stl).
4. If you want to play without a cartridge, I completely closed version (3) at the top (TJP_casefrontChipEx_closed.stl).
5. The cartridge case was very narrow, especially if you had stickers on the cartridge. I widened it a bit (TJP_cartrige