Case Raspberry Pi Camera Module v1.3

I wanted a slim no frills case to hold my Raspberry Pi Camera module. It has a ¼ 20 camera mount thread embedded into it. The Front cover is a friction fit.The STL files include a version where the mount and case are in two parts for either remixing or to print combined, but with thicker walls and infill ti support the heat insert.The ribbon cable is threaded into the back before attaching to the camera.You will probably want a dab of glue to hold the circuit board in place, the pins are a loose fit.Or you could squash them down with a hot soldering iron to trap the board. Print settingsPrinted without supports in a black basic PLAThe front and main part of the case had 3 walls and 10% infillThe part with the mount had 6 walls and a probably exisve 90% infill. You can probably get away with much less, but I didn't want it deforming when I put the heat insert in.This model acted somewhat as a test print for adding a heat insert. Boost MeIf you like it, or used it, show your apprecia