Cat door

A cat door with a tunnel that is 133mm long. The door and tunnel is one print, the hinges for the door prints in place.The frame for the other side is a separate print that will fit with the end of the tunnel. The frame and the door has 3 holes for screws. -UPDATE!-I have improved the hinge for both models 50mm and 133mm tunnels. Thank you for commenting when there is something wrong with the model! I chose to paint my print afterwards and glue some plastic leafs on to it. I also paused my print to place a piece of acryllic plastic as a window (there is a space for that). In this model i have chosen to have support in that space so if you choose to have a plastic window please remove the support between the window frames!!There is also room for a smaller magnet to put in to the handle of the door if you would like to leave the door open and a bit secure towards the wall. For this i drilled a hole that matched the magnet size and glued it in the door.To put the magnet in the handle you