Thingiverse
Cat Ring
von JaY_III
29
Downloads
31
Likes
0
Makes
Prints very nice using .1mm Layer height
also works with .2mm
I use PETG but should be fine with PLA
The Inner diameter is 15mm
Fits ring finger on 6-7 year old girls hand.
also works with .2mm
I use PETG but should be fine with PLA
The Inner diameter is 15mm
Fits ring finger on 6-7 year old girls hand.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
