Thingiverse
Catamaran for hover:bit
por MakeKit
2
Descargas
0
Likes
0
Makes
See video tutorial: https://www.youtube.com/watch?v=mjkiQWbEbqw
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
