Catan Interlocking tile storage

Update: added some pictures of the painted box and a template for the logo

I needed a storage box for the interlocking catan 3D board.
I printed all my tiles interlocking on all sides.
This way the scenery can be glued to the base since they are all the same.
I created separate edge pieces to be used as a brim.

For a normal catan board layout you need following pieces to create the brim:
18x catan corner pieces
6x catan-edge-small
3-1-3-1-3-1-3-1-3-1-3-1


For the storage I started with a cheap wooden box.
Inside measurements:
282x182x108 mm with extra room in the lid.

Inside divider: 280x100x3.5 mm
Mine is made out of multiplex, but could be printed aswell.

Use 4 fixtures to place the divider (optionally 1 extra fixture on the bottom for more stability)

For the Vertical tile storage print:
2x big-center
2x small-center
2x big-outside
2x small-outside

These can be glued to the inside of the box and divider

For the trays print 16 supports (