Cateye Quick Stem Mount

Provides an alternative way to mount your Cateye Quick cycle computer directly to the step top cap. Important! This is not meant to replace your top cap. It is not safe and nor designed ti be used to tighten your stem. Steps: Most stems have 2 side bolts to keep the stem secured to the steerer tube. You should not have to remove or adjust these. Remove the hex bolt, but keep the stock top cap in place. Insert the hex bolt through the printed unit, then secure in the stem. Only tighten enough to secure the top printed Quick holder. Pop the Quick in. It may have a loose fit, which can easily be remedied by adding a strip of thin foam tape under the Quick to take up the gap. Disclaimer: This holder is not intended to replace the stem top cap. It is not a mechanism to secure your stem to your steerer tube. Do not remove the top cap and replace with this unit thinking it will do that job. You must retain your stock setup you had prior to doing this. If you are unsure of what you are doing,