Slicer Discord
CCTV security camera junction box – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

CCTV security camera junction box

84 Downloads
53 Likes
46 Makes
Zum Modell
I needed junction box for one of my installs and here we go!I work perfectly fine for indoor and outdoor installs , but it is not waterproof so make sure that you will use waterproof connectors for you camera wire.Works good with ¾ pipe threaded PVC connectors but you might run the connector twice to clean the thread.Use #6 screws for the cover (or m4) and connect you camera with any crew you like direct on the box cover. Its is a generic box that will fit most of the dome cameras on the market.Enjoy It!
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen