CE3_Pi_Zero_Case

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/kvGEExKXSZH

*****Update****

I made some additional changes and printed V4. V4 does work! As always...GL and happy printing!

*** Update***

I began printing this one and noticed that the mounting holes were not going to fit the Raspberry Pi Zero Properly. I have deleted the Original and replace it with V2. I believe that
the mounting holes in V2 will line up properly.

The walls are fairly thin; so, I sliced it using %50 infill and have it running at about 30mm/sec.

I am re-printing this one now and will give an update when it finishes.

I also notice a weak corner...V3 should resolve that.

***End of Update ***

I had wanted a Raspberry Pi Zero case that would slide into the rails of the aluminum frame. I had also wanted it to have a fan enclosure, as I am running OctoPrint with this and did not want it to overheat.

The space for the fan is an enclosure only with some hollow