Thingiverse
Ceiling Hooks
door dyermaker504
8
Downloads
35
Likes
0
Makes
UPDATE: Have held up for 3+ years. Added an updated version (Updated_FishingRodHook.stl) that addresses sagging I've seen over the 3 years to increase strength where needed. Could also just print in higher infill and that would probably take care of it completely.
Pair of hooks that you can hang from ceiling. I have not load tested them exactly, but in PLA+, they have held up my heaviest surf fishing rods with only the 3x drywall screws for a year. Good to go.
Model should be laying down to print without supports.
Pair of hooks that you can hang from ceiling. I have not load tested them exactly, but in PLA+, they have held up my heaviest surf fishing rods with only the 3x drywall screws for a year. Good to go.
Model should be laying down to print without supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
