Ceiling Light Shade

This two shade ceiling fixture works with those cheap, two-bulb fixtures you see in a lot of bedrooms without ceiling fans. I was tired of looking at the bare bulbs so I put this together.

I designed in two shades to keep the prints small enough for tiny beds and all parts are designed to be printed without supports or brims.

Depending on the length of the ceiling to the mount base at the bottom you may need to slice a bit from the top of the shroud model in your slicer, or simply use without the shroud, all it does is cover the ugly metal fixture anyways.

Disclaimer: I should probably note that even using compact fluorescent bulbs instead of LED bulbs may be too hot for your filament, my shades are holding up fine with CFLs but yours may not... I would never recommend incandescent bulbs though, they just put off way to much heat! Also, LED bulbs are common place now, cost a tenth of the price in electricity, and put off almost no heat... I love the future!