Thingiverse
Ceiling Spool Holder
von Poulpc
4
Downloads
4
Likes
0
Makes
i have been testing it for a long time, i was afraid it was just going to unspool it on the floor, but i have printed 6 full rolls with it so far (1kg/1.75 pla) and it has not done it so far
remember to run it from the top of the roll not the buttom
remember to run it from the top of the roll not the buttom
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
