Centech Multimeter Holder

I was getting tired of having to hold my cheap multi-meter to see the screen.
I designed this to hold it for me. I added a place for the probes to sit and an open section for small items.
I designed it so that you can slide it up and down to change the angle of the device. I left a tiny bit of the brim to make it a slight friction fit.
I did consider adding some sort of provision for wrapping up the wires, but they're so cheap I don't like to wrap them too much because they crack.

I printed it with the "bottom" flat to the build plate to eliminate the need for any supports.

I hope you like it!